Table 7.2: Parameters That Work With The Cli Add Command - Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual

108 MergePoint Service Processor Manager SP53XX Installer/User Guide
example, to add a service processor user, you must enter
user must then be configured after adding, using the

Table 7.2: Parameters that Work with the CLI add Command

Parameter Level 1 Parameter Level 2
dhcpd
iptables
network
pxe
snmpd
mapping
nat | filter
interface
hosts
st_routes
mapping
user
add spmanager user <username>
command.
set
What It Configures (Syntax)
Add a MAC address for IP.
Synopsis: add adhpd mapping <MAC_address>
Example: add dhcpd mapping 00602e01d9a6
NOTE: No colon (:) is needed in the MAC address.
See the set command for the following parameters:
dhcpd setting subnet, dhcpd setting relay and dhcpd
mapping on page 117.
Firewall configuration. Add a new rule to NAT table
and filter table.
Synopsis: add iptables nat
[PREROUTING|POSTROUTING|OUTPUT]
<number>| filter [INPUT|OUTPUT|FORWARD]
<chainname>
Example: add iptables nat PREROUTING 0
Add an alias to an interface.
Synopsis: add network interface <interface> alias
<alias_name>
Example: add network interface eth1 alias yd
Add an IP address for a host.
Synopsis: add network hosts <IPaddress>
Example: add network hosts 172.26.25.178
Add to the list of static route targets a subnet or host
(networks in the form 1.2.3.0/24 or host IPs).
Synopsis: add network st_routes
<network_IPaddress/netmask> | <host_IPaddress>
Example: add network st_routes 1.1.1.1
Add a MAC address.
Synopsis: add pxe mapping <MAC_ address>
Example: add pxe mapping 00602e01d9a6
NOTE: No colon (:) is needed in the MAC address.
See the set command for the following parameters:
pxe mapping and pxe setting on page 120.
Add a user and fills in the subtree with default values
and randomly generated passwords.
Synopsis: add snmpd user <user_name>
Example: add snmpd user user1
; the