Adding The Mergepoint Sp Manager To A Dsview 3 Software Installation; Configuring The Mergepoint Sp Manager Network Settings; Ethernet Ports On The Mergepoint Sp5300 Appliance - Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual

configure the MergePoint SP5300 appliance with the master key and slave key(s) for the new
license key(s).
To activate the MergePoint SP5300 appliance license:
1. Follow the instructions on the registration card included with the MergePoint SP5300
appliance to activate the appliance serial number. Once completed, you will receive a master
license key.
2. Open a web browser and enter the IP address (
the appliance.
3. The MergePoint SP5300 appliance web interface window appears. Type the master key in the
fields provided and click Add.
4. The User Login window appears. Type
password. To change the admin password, see To add an appliance user (Admin users only):
on page 22.
To view license information (Admin users only):
5. Click System – Licenses for a license summary and list of license keys and descriptions.
To add a master or slave key:
1. Click the System tab.
2. In the top navigation bar, click Licenses. The License window appears.
3. Click Add Master Key or Add Slave Key and type the master key.
4. Click Apply.
Adding the MergePoint SP Manager to a DSView 3
Software Installation
If you will be using the MergePoint SP manager within a DSView 3 software installation, you may
now use the DSView 3 software Add Appliance wizard to add the MergePoint SP manager and
finish configuration. For detailed instructions, refer to the DSView 3 software installer/user guide.

Configuring the MergePoint SP Manager Network Settings

Ethernet ports on the MergePoint SP5300 appliance

The MergePoint SP5300 appliance has two public Ethernet ports (eth0 and eth1), which are labeled
LAN1 and LAN2. The eth0 port is for connecting to the external network and eth1 is for
connecting to service processors on the internal network.
NOTE: Connecting service processors to eth0 is not recommended because some services, like BMC
provisioning or DHCP servers, only listen to eth1.
Chapter 2: Installation and Setup
http://<appliance IP address>
as the username and type
admin
13
) of
as the
admin