Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual page 147

/admin1-> show /map1/ipendpt1 IPv4Address
/map1/ipendpt1
properties
/admin1-> show /map1/ipendpt1 IPv6Address
/map1/ipendpt1
properties
Showing Ethernet port of MergePoint SP manager
You can show ethernet port of MergePoint SP manager. Use the following properties with the show
command on the /admin/map1/enetport1 target:
To show ethernet port of MergePoint SP manager:
Show ethernet port of MergePoint SP manager by entering the show command, followed by the
target, followed by portnumber:
/admin1-> show /map1/enetport1 PortNumber
/map1/enetport1
properties
subtargets
Showing Telnet and SSH services on the MergePoint SP manager
The /admin/map1/telnetsvc1 target is the Telnet service and the /admin/map1/sshsvc1 target is the
SSH service on the appliance. The /admin1/map1/tcpendpt1 target is the association of target /
admin/map1/sshsvc1. The /admin1/map1/tcpendpt2 target is the association of /admin/map1/
telnetsvc1 target. Supported commands is: show properties. Supported properties are: idletimeout,
port, etc.
To show Telnet and SSH configuration:
1. Show the idle timeout by entering the show command, followed by the target, followed by
idletimeout. The unit of timeout is second.
The following example shows the idle timeout for the SSH service.
/admin1-> show /map1/sshsvc1/sshsetting1 idletimout
/admin1/map1/sshsvc1/sshsetting1
properties
Chapter 8: Using SMASH Command Line Management
IPv4Address = 172.26.25.164
IPv6Address = 2001:ac1a:11:3:230:48ff:fe85:edd4/64
PortNumber = 0
IdleTimeout = 18000
133