Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual page 148

53xx series service processor manager
Table of Contents

Advertisement

134
MergePoint Service Processor Manager SP53XX Installer/User Guide
2.
Show the port number by entering the show command, followed by the target, followed by
portnumber.
The following example shows the port number for the Telnet service.
/admin1-> show /map1/tcpendpt2 portnumber
/admin1/map1/tcpendpt2
Configuring automatic discovery of supported server types
The admin1/map1/oemavocent_discoverysap1 target is for the automatic discovery service, which
finds servers that have the supported service processor technologies when the IP addresses for the
service processors are within the defined IP address range. You can set two different ranges of IP
addresses for automatic discovery through the discovery service access point targets
oemavocent_startip and oemavocent_endip. Supported commands are: set properties, start and
stop. To see all the properties, run:
oemavocent_discoverysap1
NOTE: -all option is for OEM, and it also for showing the associations of targets.
To configure automatic discovery:
1.
Configure the automatic discovery range by entering the set command, followed by the target
followed by oemavocent_startip="startip" oemavocent_endip="endip".
/admin1-> set /map1/oemavocent_discoverysap1
oemavocent_startip="172.26.25.1" oemavocent_endip="172.26.25.100"
oemavocent_startip=172.26.25.1
oemavocent_endip=172.26.25.100
2.
Set the start mode of automatic discovery by entering the set command followed by the target.
/admin1-> set /map1/oemavocent_discoverysap1
oemavocent_startmode="manual"
NOTE: The valid "oemavocent_startmode" values are "automatic" and "manual".
3.
Disable the discovery service by entering the stop command followed by the target.
/admin1-> stop /map1/oemavocent_discoverysap1
/map1/oemavocent_discoverysap1 stopped at Sun Feb
4.
Enable the discovery service by entering the start command followed by the target.
/admin1-> start /map1/oemavocent_discoverysap1
/map1/oemavocent_discoverysap1 started at Sun Feb
properties
PortNumber = 23
/admin1/-> show -all /map1/
3 18:48:21 2008
3 14:47:46 2008

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MERGEPOINT 53XX SP MANAGER and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Mergepoint sp5300Mergepoint sp5324Mergepoint sp5340

Table of Contents