Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual page 114

100 MergePoint Service Processor Manager SP53XX Installer/User Guide
NOTE: The definitions for the values are:
- auto: Auto mode. The system selects an appropriate speed for the switch port.
- 10f / 10h / 100f / 100h: Mandatory mode. The system cannot change the value. This setting may cause
operations to fail if the value is not appropriate for the switch port.
- 10F / 10H / 100F / 100H: Negotiable mode. System may use this value, or set another value if this value is
not appropriate for the switch port.
To get the individual port speed:
1. Log into the MergePoint SP manager console as
2. Retrieve the current speech of the switch port using the following command:
sysctl –n marvell.xxx
NOTE: The xxx value is the switch port number. The output is the current speed of the switch port. The current
speed may differ from the speed you set if you chose auto mode or negotiable mode for the speed value.
.
root