Associations; Managing Mergepoint Sp Manager - Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual

132 MergePoint Service Processor Manager SP53XX Installer/User Guide
To set a property of a target:
Enter the set command, followed by the target name, followed by the name of the property and the
desired value, in the form: property=value.
The following command line sets the output format of a CLP session to text on the MergePoint SP
manager.
-> set /admin1/map1/clpsvc1/clpendpt61 outputformat=text

Associations

MergePoint SP manager CLP supports associations. The association separator "=>" is used to
address association instances.
To obtain the associations:
Enter the desired target level and type the show command, followed by "=>", followed by an
association instance.
For example, to obtain the association of /admin1/map1/clpsvc1 target, enter the following
command:
/admin1-> cd /admin1/map1/clpsvc1
/admin1/map1/clpsvc1
/admin1/map1/clpsvc1-> show =>hostedservice
/admin1/map1/clpsvc1

Managing MergePoint SP manager

MergePoint SP manager is managed with the /admin1/map1.
You can perform management of MergePoint SP manager using CLP commands showed in this
section.
Showing IP address of MergePoint SP manager
You can show IP address of MergePoint SP manager. Use the following properties with the show
command on the /admin/map1/ipendpt1 target:
To show IP address of MergePoint SP manager:
Show IP address of MergePoint SP manager by entering the show command, followed by the
target, following by ipv4address or ipv6address:
associations
hostedservice :
Antecedent = /admin1/map1
Dependent = /admin1/map1/clpsvc1