Cli Commands; Add - Avocent MERGEPOINT SP MANAGER Installer/User Manual

MergePoint® SP Manager Installer/User Guide
126
bootconf iptables pxe sshd tcpdump
Pressing
Tab
parameter name, unless there is more than one parameter name beginning with the typed
characters. If more than one parameter name begins with the typed characters, then
displays them all.
NOTE: The bootconf and cards commands are only for MergePoint SP5x24/SP5x40 manager.
Examples
cli> s<Tab><Tab>
set shell show
cli> se<Tab>
cli> set
cli> set n<Tab><Tab>
network ntp
cli> set ne<Tab>
cli> set network
cli> set network <Tab><Tab>
hostname hosts interface resolv st_routes
cli> set network i<Tab>
cli> set network interface
cli> set network interface eth0 <Tab>
address alias gateway method mtu netmask
address6 broadcast gateway6 method6 mtu6 netmask6

CLI Commands

The CLI utility supports the commands that are described in the following sections with
examples.
cli> <Tab><Tab>
add commit exit list rename set show
cd delete get quit revert shell version

add

The add command adds the last parameter and sets it to the default value (if any). Any
nondefault values must be set using the
The command is used instead of
add
For example, add network hosts <IP address> makes an entry for a host with the specified IP
address in the hosts list. In that case, add is used because multiple hosts can exist.
once after partially typing a parameter name automatically completes the
command.
set
when multiple parameters of the same type can exist.
set
Tab Tab