Avocent MERGEPOINT 53XX SP MANAGER Installer/User Manual page 123

Table 7.2: Parameters that Work with the CLI add Command (Continued)
Parameter Level 1 Parameter Level 2
group
view
access
com2sec
proxy
syslog destination
spmanager server
Chapter 7: Using the CLI Utility
What It Configures (Syntax)
Add a group.
Synopsis: add snmpd group <group_name>
Example: add snmpd group g1
Add a view.
Synopsis: add snmpd view <view_name>
Example: add snmpd view ies
Add an access type.
Synopsis: add snmpd access
<noauth|auth|authpriv>
Example: add snmpd access auth
Add a com2sec type.
Synopsis: add snmpd com2sec <type>
Example: add snmpd com2sec mp1
Add an snmpd proxy.
Synopsis: add snmpd proxy <proxy_name>
Example: add snmpd proxy 0
Add the name of syslog server to the default console
or rootuser destinations defined for syslog
messages.
Synopsis: add syslog destination <server_name>
Example: add syslog destination dest1
Two steps are required to add a server to the
appliance:
1) Add a managed device to the appliance.
Synopsis: add spmanager server <device_name>
2) Configure the device parameters for the
appliance.
Synopsis: set spmanager server <devicename>
account_verify <yes|no> type <typename> ip <IP
address> user <username> password <password>
group <group name>
Example: add spmanager server 172.26.25.236
set spmanager server 172.26.25.236 account_verify
no type IBMBC ip 172.26.25.236 user USERID
password PASSW0OD group MergePoint
NOTE: The group means the server group. The
default group is MergePoint.
To specify an alias or sol port to the server, see the
set command for the following parameter:
spmanager server on page 122.
109