Table 7.3: Setting Top Level CLI Parameters (Continued)
Parameter
Command
auth
Use the set command with the type parameters to set an authentication type for logins to
the MergePoint SP manager, either krb5, ldap, nis, radius, smb, or tacplus.
Use the set command with the auth type ppp parameters to set an authentication type for
logins through the auxport modem and pcmcia/cardbus modems.
Authentication types supported for the MergePoint SP manager and for target devices are
listed in Configuring External Authentication Services on page 67.
Synopsis: set auth type <typename> nis domainname <name> server <ip|broadcast>
radius|tacplus accthost <server-name> authhost <server-name> secret <secret> timeout
<count> retries <count> tacplus service <ppp|raccess> krb5 realm <realm> server <ip-
address> ldap host <host> base <base-name> binddn <dn> bindpw <password>
pam_login_attribute <attribute> ssl <on|off|start_tls> smb domain <name> server <ip-
address>
Example: set type local nis domainname subavt server 1.1.1.1 radius authhost1 a1
authhost2 a2 accthost1 c1 accthost2 c2 secret pwd timeout 4 retries 2 tacplus authhost1
1.1.1.1 authhost2 12.2.2.2 accthost1 1.1.1.1 accthost2 12.2.2.2 secret pwdd retries 2
timeout 4 service ppp krb5 realm dm server 2.2.2.2 ldap host 127.0.0.1 base
dc=padl,dc=com binddn bdl bindpw pwd pam_login_attribute df ssl on smb domain sudom
server1 2.2.2.1 server2 3.3.3.3
bootconf
Use the set command to configure boot configuration.
Synopsis: set bootconf wdt <yes|no> mac <mac address> ip <ip address> bootfile <file
name> serverip <tftp server ip> baudrate
<1200|2400|4800|9600|19200|38400|57600|115200> fecmode1|fecmode2
<auto|100F|100H|100F|10F|10H> BF_curr < 0| 1 |2>
Example: set bootconf wdt yes mac 00:60:2e:01:d9:a6 ip 172.26.25.177 bootfile
uImage.4.0.0.28 baudrate 9600 fecmode1 auto fecmode2 auto BF_curr 1
NOTE: This parameter is only for the MergePoint SP5324/SP5340 appliance.
dhcpd setting
Use the set command to configure dhcpd settings.
subnet
Synopsis: set dhcpd setting subnet <subnet name> range_low <start ip> range_high
<end ip>
Example: set dhcpd setting subnet 199 range_low 199.1.1.1 range_high 199.1.1.160
dhcpd setting
Use the set command to specify a DHCP relay server.
relay
Synopsis: dhcpd setting relay server <relay server> status <yes/no>
Example: set dhcpd setting relay server 172.26.25.3 status yes
dhcpd mapping
Use the set command to specify an IP address for added MAC.
Synopsis: set dhcpd mapping <MAC_address> ip <ip_address>
Example: set dhcpd mapping 00602e01d9a6 ip 1.1.1.1
NOTE: See the add command for the following paramter: dhcpd on page 108.
Chapter 7: Using the CLI Utility
117
Need help?
Do you have a question about the MERGEPOINT 53XX SP MANAGER and is the answer not in the manual?
Questions and answers