Configuration Branch; Options; User Storage Areas; Remote Dsu - Paradyne COMSPHERE
3610 User Manual

COMSPHERE 3600 Series Data Service Units

Configuration Branch

The Configuration (Confg) branch allows you to
configure or customize the DSU and its options to:
Fit site requirements.
Enter and change telephone numbers (if a DBM is
installed).
Specify the protocol used by a connected NMS.
TOP-LEVEL MENU
Local
Stat Bckup
Opts PList Dir Phone
Clr Add
Displ Chang Acq
Activ Skip
Delet
Load
Activ Remt
Usr1
Address
Activ Usr1 Usr2 Usr3
SAVE DSU Diag DBM
DSU DBM Gen
Activ Remt Usr1 Usr2
Address
Activ Usr1 Usr2 Usr3
3-14
Remot Msgs
Address
Ctrl
Test
Confg
Addr Term SPID Menu
ChgMd
Save ADp
Save Disab
Enab
DPII
Enab Disab Pswrd CID
Pswrd
Usr3 FacT MPTC
Usr2 FacC FacB MPTT
Gen Bkup MUX PrtSp LPDA
Usr3
496-12973b

Options

Options (Opts) allows you to save, copy, and/or
change DSU, Diagnostic, DBM, General, Backup, MUX,
and LPDA-2 configuration options.
The selections on the Load from menu are sets or
libraries of configuration options stored in the DSU's
memory. Refer to:
Saving and Changing Configuration Options
section in Chapter 2
Table 2-1 in Chapter 2 for default configuration
option set content descriptions
Table A-1 in Appendix A for all DSU factory
default configuration option settings
Table E-4 in Appendix E for Configuration Error
Messages

User Storage Areas

Usr1, Usr2, and Usr3 are storage areas for user-defined
configuration option sets. Use these storage areas to:
Maintain predetermined option sets for specified
DSU, Diag (DSU, DBM, and Gen), DBM, Gen,
Bkup, and LPDA configurations.
Permit the rapid loading of an entire configuration
option set after changes have been saved for reuse.
Save the time required to change each individual
configuration option.
If configuration option changes are entered in Active,
the current set of options are restored if a power-up test
occurs.

Remote DSU

Selecting Remt from the Load from menu results in
configuration options appearing based on hardware
installed at the remote location.
Remt requires a remote address. The remote address
selections range from 1 to 255 for ADp protocol and 1 to
80 for DPII protocol. If you want to save configuration
options to all of your remote devices, select the broadcast
address ( 192). After the configuration options are saved,
the changed configuration options are broadcast to the
entire network once.
When configuring remotely, it is recommended that the
control and tributary DSUs have the same firmware
version, or that the control has the highest version.
December 1996 3610-A2-GB46-60