Brocade Communications Systems StoreFabric SN6500B Administrator's Manual page 111

Brocade web tools administrator's guide v7.1.0 (53-1002756-01, march 2013)
Hide thumbs Also See for StoreFabric SN6500B:
Table of Contents

Advertisement

The Inband Management interface is protocol independent, so any traffic destined for these
Inband Management interfaces is passed through the distribution point to the control processor. It
is then handled on the control processor, according to the rules set forth for the normal
management interface and following any security rules that may be in place on the control
processor.
To provide redundancy, there is one inband management interface per GigE port. This allows the
management station on the WAN side of the network to have multiple addresses with which to
reach that switch, and allow redundancy in the event one of the GigE ports becomes unreachable
for any reason.
Communication is handled through external addresses that are configured independently for each
Inband Management interface. The Inband Management interfaces share the routing table on the
control processor. This is separate from the routing table for each GigE port that exists. Because of
this there are certain limits to the addresses that are allowed, and the routes that are allowed for
the Inband Management interfaces and route entries.
Inband Management is supported on the Brocade 7800 and Brocade FX8-24. Only one IP interface
entry can be configured per GigE port.
To configure Inband Management, perform the following steps.
1. Select Port Admin > GigE Ports > Inband IP Interface.
2. Click Add to configure a new Inband Management entry.
3. Set the IP Address Type to IPv4 .
4. Set the address options:
5. Click OK.
6. Select the Inband IP Routes tab.
7.
8. Set the IP Address Type to either IPv4.
9. Set the address options of the management station on the WAN side of the FCIP platform:
10. Click OK.
11. Select the General sub-tab.
12. Select the Enable option from the Inband selection list to activate Inband Management.
Web Tools Administrator's Guide
53-1002756-01
-
IP Address
-
Subnet Mask
-
MTU Size
Click Add to configure a new route entry.
You can create a maximum of 32 Inband IP Route entries.
-
Destination IP Address
-
Subnet Mask
-
Gateway IP Address
Inband Management
5
83

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents