The Port Connectivity table (shown in
physical-location format), Port Name (port address name), Block attribute, Prohibit attribute, and
Area Id (port address, displayed in hexadecimal) in fixed columns. The right side is a port matrix,
that lists all ports by Area ID and identifies prohibited ports. Those columns are scrollable and
swappable.
Viewing Allow / Prohibit Matrix configurations
To display a list of Allow / Prohibit Matrix configurations, perform the following steps.
1. Select a FICON-enabled switch from the Fabric Tree.
2. Select Configure > Switch Admin.
3. Click Show Advanced Mode to see all the available tabs and options.
4. Select the FICON CUP tab.
5. Click the Allow / Prohibit Matrix subtab.
Modifying Allow / Prohibit Matrix configurations
In the Allow / Prohibit Matrix Configuration dialog box, swapped ports are indicated with the
"(Swapped)" label
FIGURE 44
To create a new Allow / Prohibit Matrix configuration or to edit an existing configuration, perform
the following steps.
1. Display the Allow / Prohibit Matrix configuration list.
2. You can either create a new configuration or edit an existing configuration:
Web Tools Administrator's Guide
53-1002756-01
The FICON CUP page displays the FICON Management Server page in front. All attributes on
this page are read-only until FMS mode is enabled.
(Figure
44).
Edit Allow / Prohibit Matrix dialog box swapped label
•
To create a new configuration, click New.
Allow / Prohibit Matrix configuration
Figure 45
on page 209) displays the Port number (in
16
207