Configuring Dynamic Load Sharing; Lossless Dynamic Load Sharing - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

Configuring dynamic load sharing

The exchange-based routing policy depends on the Fabric OS dynamic load sharing feature (DLS)
for dynamic routing path selection. When this policy is in force, DLS is always enabled and cannot
be disabled.
When the port-based policy is in force, you can enable DLS to optimize routing. When DLS is
enabled, it shares traffic among multiple equivalent paths between switches. DLS recomputes load
sharing either when a switch boots up or each time an E_Port or FX_Port goes online or offline.
Enabling this feature allows a path to be discovered automatically by the FSPF path-selection
protocol.
For more information regarding DLS, refer to the dlsset command in the Fabric OS Command
Reference.
To configure dynamic load sharing, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the Routing tab.
3. Select On in the Dynamic Load Sharing (DLS) area to enable dynamic load sharing or select Off
4. Click Apply.
5. Click OK.

Lossless dynamic load sharing

Lossless dynamic load sharing (DLS) is supported in following platforms:
•
•
•
•
•
•
•
•
•
•
•
•
Web Tools Administrator's Guide
53-1002756-01
window" on page 31.
to disable dynamic load sharing.
When the exchange-based routing policy is in effect, the DLS radio buttons display on the
Routing tab
The warning message, "Credit Recovery for Long distance links should be turned off using CLI
while enabling DLS" displays.
Brocade FC16-32
Brocade FC16-48
Brocade DCX with 8G blades
Brocade DCX-4S with 8G blades
Brocade 300
Brocade 5100
Brocade 5300
Brocade 6505
Brocade 6510
Brocade 6520
Brocade 7800 on FC ports.
Brocade FX8-24 on FC ports.
Configuring dynamic load sharing
"Opening the Switch Administration
14
159