Modifying The Radius Server - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

15
RADIUS management
You can configure RADIUS even if it is disabled. You can configure up to five RADIUS servers. You
must be logged in as admin, switchadmin, or securityadmin to configure RADIUS.
To configure RADIUS, perform the following steps..
1. Open the Switch Administration window as described in
2. Select the AAA Service tab.
3. Click Add.
4. Select RADIUS from Server Type.
5. Enter the RADIUS server name, as a valid IP address (in either IPv4 or IPv6 format) or Dynamic
6. Enter the port number.
7.
8. Enter the timeout time in minutes.
9. Select either CHAP or PAP as the authentication protocol.
10. Click OK to return to the AAA Service tab.
11. Click Apply.

Modifying the RADIUS server

To change the parameters of a RADIUS server that is already configured, perform the following
steps.
1. Open the Switch Administration window as described in
2. Select the AAA Service tab.
3. Select a RADIUS server from the RADIUS Configuration list.
4. Click Modify.
5. Enter new values for the port number, timeout time (in minutes), and secret string.
6. Select either CHAP or PAP as the authentication protocol.
7.
8. Click Apply.
184
window" on page 31.
The RADIUS/ADLDAP/TACACS+ Configuration dialog box displays. You can configure up to five
RADIUS servers. If five RADIUS servers are already configured, the Add button is disabled.
Name Server (DNS) string.
Each RADIUS server must have a unique IP address or DNS name for the RADIUS server.
Enter the secret string.
The default value is CHAP, and if you do not change it, CHAP becomes the authentication
protocol.
window" on page 31.
The RADIUS/ADLDAP/TACACS+ Configuration dialog box displays.
The default value is CHAP, and if you do not change it, CHAP becomes the authentication
protocol.
Click OK to return to the AAA Service tab.
"Opening the Switch Administration
"Opening the Switch Administration
Web Tools Administrator's Guide
53-1002756-01