Fabric-Wide Consistency Policy Configuration - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

3. Select the Security Policies tab to configure the ADS policy in Access Gateway mode.
4. Select the ADS option.
5. Select the Enable ADS Policy option.
6. Optional: Select an F_Port from the table and click the Edit button.
7.
8. Optional: You can add the detached port WWN to the selected WWN's list by adding the WWN
9. Optional: For a selected F Port, if you select the Show device WWN connected to this port

Fabric-Wide Consistency Policy configuration

Fabric-Wide Consistency Policy (FWCP) configures the Fabric Wide Consistency behavior of
distributable ACL policies. The policy ensures that the switches in the fabric enforce the same
policies. Set a strict or tolerant fabric-wide consistency policy for each ACL policy type (SCC, DCC,
FCS) to automatically distribute that database when a policy change is activated. If a fabric-wide
consistency policy is not set, then the policies are managed on a per switch basis.
To set the fabric-wide consistency policy for an SCC, DCC or FCS policy, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the Security Policies tab.
3. Under Security Policies, click FWCP.
4. Select one of the following consistency behavior for the required policy type (SCC, DCC, FCS).
5. Click Apply.
6. Click Yes to accept the changes.
7.
Web Tools Administrator's Guide
53-1002756-01
The Configure Advanced Device Security Port WWN table displays.
The ADS Port WWN Configuration dialog displays. You can configure device port WWN's that
can be allowed to login to a particular F_Port by adding them to the Selected WWN list.
Select either All Access, or a list of selected WWNs.
in the detached WWN text field and clicking Add.
check box of the ADS Port WWN Configuration dialog, only connected devices are listed in
Available WWN's list. When you deselects the check box, all the connected device port WWN's
and detached WWN's added to the AG are listed in the Available WWN's list.
window" on page 31.
•
Absent
•
Tolerant
•
Strict
NOTE
You can change the consistency behaviors of SCC, DCC, or FCS policy only for a primary switch.
NOTE
If the switch is not a primary switch, an error message dialog box displays.
Click No to discard the changes and click Refresh in the FWCP Configuration window to
manually refresh the window.

Fabric-Wide Consistency Policy configuration

"Opening the Switch Administration
15
177