Restoring A Configuration - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

4

Restoring a configuration

6. Use the Fabric ID selector to select the fabric ID of the logical switch from which the
NOTE
If you are using a USB device, it must be connected and mounted before you upload or download.
Refer to
7.
Restoring a configuration
Restoring a configuration involves overwriting the configuration on the switch by downloading a
previously saved backup configuration file. Perform this procedure during a planned down time.
Make sure that the configuration file you are downloading is compatible with your switch model.
Configuration files from other model switches might cause your switch to fail.
If you download from a network, enter the host name or IP address in the Host Name or IP field, the
user ID and password required for access to the host in the User Name and Password fields, and
select the Protocol Type used for the upload. The default is FTP. If you select "Secure Copy Protocol
(SCP)," you cannot specify "anonymous" in the User Name field.
To restore a configuration, perform the following task.
1. Open the Switch Administration window.
2. Select Show Advanced Mode.
3. Select the Configure tab.
4. Select the Upload/Download tab.
5. Under Function, select Config Download to Switch.
56
If you select USB as the configuration file source, the network parameters are not needed and
are not displayed. You can skip to step 6.
configuration file is to uploaded.
The selector displays all the virtual fabric IDs that have been defined, the default of 128 for the
physical switch, chassis level configuration, and all chassis and switches.
FIGURE 13 Fabric ID selector
"Uploading and downloading from USB storage"
Click Apply.
You can monitor the progress by watching the Upload/Download Progress bar.
By default, Config Upload is chosen under Function, and Network is chosen as the source of
the configuration file.
If you select USB as the configuration file source, the network parameters are not needed and
are not displayed, and you can skip to step 7.
on page 57 for more information.
Web Tools Administrator's Guide
53-1002756-01