Configuring Netstat Auto Refresh; Configuring A Syslog Ip Address; Removing A Syslog Ip Address - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

3

Configuring Netstat Auto Refresh

Configuring Netstat Auto Refresh

The Netstat Performance window displays the details about Ethernet management port statistics
like the Interface, MTU, Met, RX-OK, RX-ERR, RX-DRP, RX-OVR, TX-OK, TX-ERR, TX-DRP, TX-OVR, and
Flag.
To configure Auto Refresh, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the Network tab.
3. Click Netstat Performance.
4. Select the Auto Refresh check box to automatically refresh the port details.
5. When enabled, enter the interval time in seconds in the Auto-Refresh Interval field.

Configuring a syslog IP address

The syslog IP represents the IP address of the server that is running the syslog process. The syslog
daemon reads and forwards system messages to the appropriate log files or users, depending on
the system configuration. When one or more IP addresses are configured, the switch forwards all
error log entries to the syslog on the specified servers. Up to six servers are supported. Refer to
Fabric OS Administrator's Guide for more information on configuring the syslog daemon.
To configure a syslog IP address, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the Network tab.
3. In the Syslog IP's Configuration section, in the New IP field, enter an IP address in either IPv4
4. Click Add.
5. Click Apply.

Removing a syslog IP address

To remove a syslog IP address, perform the following steps.
1. Open the Switch Administration window as described in
2. Select the Network tab.
3. Select a syslog IP in the table and click Remove.
32
window" on page 31.
Clear the check box to disable auto refresh.
The port details are automatically refreshed, based on the configured time interval. The
minimum value is 15 seconds.
window" on page 31.
or IPv6 format.
The new IP address displays in the Syslog IP area.
window" on page 31.
"Opening the Switch Administration
"Opening the Switch Administration
"Opening the Switch Administration
Web Tools Administrator's Guide
53-1002756-01