Table of Contents
Advertisement
2. Insert the replacement battery 1 :
a. Hold the battery in a vertical orientation so that the smaller side is facing the socket.
b. Place the battery into its socket, and press the battery towards the socket until it clicks into place.
Make sure that the battery clip holds the battery securely.
3. Install and lock the left-side cover (see "Installing the side cover" on page 131).
4. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Note: You must wait approximately 2 1/2 minutes after you connect the server power cord to an
electrical outlet before the power-control button becomes active.
5. Start the Setup Utility and reset the configuration:
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See "Using the Setup Utility" on page 246.
6. Go to "Completing the FRU replacement."
Completing the FRU replacement
To complete the FRU replacement, you must:
v If removed, reinstall the two-piece bezel (see "Reinstalling the two-piece bezel").
v If removed, reinstall the side cover (see "Reinstalling the side cover" on page 193.)
v Connect all the cables (see "Connecting the cables" on page 194.)
v For some devices, run the Setup utility (see "Using the Setup Utility" on page 246.)
Follow the instructions in this section.
Reinstalling the two-piece bezel
To reinstall the two-piece bezel, complete the following steps:
1. Install the upper bezel on the front of the server chassis:
a. Insert the two right-side tabs on the upper bezel into the matching holes on the right side of the
chassis.
b. Rotate the upper bezel to the left side of the chassis and press the bezel clips into the matching
indentations on the left side of the chassis until the bezel clips snap into place.
190
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Hardware Maintenance Manual
Advertisement
Table of Contents
