Ids For Hot-Swap Hard Disk Drives - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

1
Filler panels
2
Drive-bay EMC shield
3
Tab
4
Hard disk drive
Step 3. Pull the loops of the drive assembly toward each other; then, carefully slide the drive assembly into
the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely seated.
Step 4. Close the drive bay EMC shield.
Step 5. Close the bezel.
Step 6. Lock the side cover.
Step 7. Reconnect the external cables and power cords; then, turn on the attached devices and turn on
the server.

IDs for hot-swap hard disk drives

Hot-swap server models have drive bays that are connected to a SAS/SATA backplane. This backplane, also
known as the hot-swap-drive backplane, is the printed circuit board behind these bays.
The hot-swap-drive backplane controls the IDs for the internal hot-swap drive bays. The following tables list
the IDs for the hard disk drives and backplane that are connected to hot-swap models.
Table 5. IDs for the four-bay 3.5-inch hot-swap drive models
Drive bay number
Drive bay 4
Drive bay 5
ID
0
1
.
Chapter 7 Installing and replacing FRUs
181