Installing The Fan Cage Cover - Lenovo ThinkServer sd350 Installation And Service Manual

Step 1. Remove the 3 M3 screws.
Step 2. Lift the cover away from the system.
Step 3. Lay the cover flat or store it for future use.
If you are instructed to return the cover, follow all packaging instructions, and use any packaging materials
for shipping that are supplied to you.

Installing the fan cage cover

Use this information to install the fan cage cover.
Before you install the fan cage cover, read "Safety" on page v and "Installation guidelines" on page 75.
If you are replacing the cover, make sure that you have the system service label kit on hand for use during
the replacement procedure.
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always
replace the compute node cover before installing the compute node.
To install the fan cage cover, complete the following steps:
Step 1. Carefully lay the Lenovo ThinkServer n400 Enclosure Type 5495 on a flat, static-protective surface,
orienting the compute node with the bezel pointing toward you.
Step 2. Orient the cover so that the posts on the inside of the cover slide into the slots on the Lenovo
ThinkServer n400 Enclosure Type 5495.
Note: Before you close the cover, make sure that all components are installed and seated correctly
and that you have not left loose tools or parts inside the Lenovo ThinkServer n400 Enclosure Type
5495. Retention clips that secure the I/O expansion adapters must be in the closed position to
install the cover.
Screws
.
Chapter 5 Removing and replacing server components
83