Dvd Drive; Removing A Dvd Drive - HP rp4410 Service Manual

DVD Drive

The DVD drive is located on the front of the server.
WARNING!
from the server before removing or replacing a DVD drive.
Voltages are present at various locations within the server whenever an ac power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
behavior or system failure. For assistance with this procedure contact your local HP Authorized
Service Provider.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions can result in damage to the server.

Removing a DVD Drive

To remove a DVD drive, follow these steps:
1. Remove the front bezel. See
2. To release the drive, grasp the front of the DVD drive and squeeze the locking tab.
222 Removing and Replacing Components
Ensure that the system is powered off and all power sources have been disconnected
Failure to properly complete the steps in this procedure results in erratic system
"Removing the Front Bezel" (page 152).