System Battery Location On I/O Baseboard - HP rp4410 Service Manual

Figure 3-18 System Battery Location on I/O Baseboard
5. To remove the battery from its socket, lift up the battery holder retaining clip with a flat-head
screwdriver and push on the back of the battery.
6. Lift up the battery holder retaining clip with a flat-head screwdriver and slide the new
battery into the holder.
NOTE: The positive terminal of the battery is designated by the plus (+) sign. The battery
is installed with the plus (+) sign facing up.
7. Replace the I/O baseboard assembly. See
8. Replace the top cover. See
9. Use the BCH DATE command, to reset the system time and date.
To verify that you installed the system battery correctly once you set the time and date,
follow these steps:
a. Power off the system.
b. Unplug the power cord.
c. Wait for a minute before turning it back on.
d. Run the DATE command again. If the time and date are now correct, you installed the
system battery correctly.
10. If necessary, reconfigure the iLO MP. See
"Replacing the I/O Baseboard Assembly" (page
"Replacing the Top Cover" (page
"Console Setup" (page
66).
104).
Installing Additional Components
71).
73