Removing And Replacing Core I/O Cards; Safety Information; Required Service Tools; Pci Slot Locations And Configurations - HP rp4410 Service Manual

9. Check the SEL for erroneous system events.

Removing and Replacing Core I/O Cards

The HP 9000 rp4410 and rp4440 servers have two I/O card slots that are dedicated for core I/O
cards.

Safety Information

Use care to prevent injury and equipment damage when performing removal and replacement
procedures. Voltages might be present within the server. Many assemblies are sensitive to damage
by electrostatic discharge.
To prevent harm to both you and the server, follow the procedures listed below to ensure safe
handling of components:
• Use an antistatic wrist strap and a grounding mat, such as those included in the Electrically
Conductive Field Service Grounding Kit (HP part number 9300-1155).
• Handle accessory boards and components by the edges only. Do not touch any metal-edge
connectors or any electrical components on accessory boards.
• Do not wear clothing subject to static charge build-up, such as wool or synthetic materials.
WARNING!
disconnected from the server before removing and replacing the core I/O cards.
Voltages are present at various locations within the server whenever an ac power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.

Required Service Tools

Service of this product can require one or more of the following tools:
• Electrically Conductive Field Service Kit (HP part number 9300-1155)
• 1/4 inch Flat Blade Screwdriver
• ACX-15 torx Screwdriver

PCI Slot Locations and Configurations

PCI slots are numbered from 1 through 8 in the server. The dedicated core I/O card slots are slots
1 and 2.
The following describes configuration requirements for slots 1 and 2:
• PCI slot 1 is dedicated for use by a SCSI HBA card. Slot 1 is not hot-pluggable. Additional
PCI expansion cards cannot be placed in slot 1.
• PCI slot 2 is dedicated for use by a LAN card. Slot 2 is not hot-pluggable. Additional PCI
expansion cards cannot be placed in slot 2.

Removing the LAN Core I/O Card

To remove the LAN core I/O card in slot 2, follow these steps:
1. If rack-mounted, slide the server out from the rack until it stops. See
Rack-Mounted Server" (page
2. Remove the top cover from the chassis. See
3. Disconnect any LAN cables connected to the LAN core I/O card.
Ensure that the system is powered off and all power sources have been
149).
"Removing the Top Cover" (page
Removing and Replacing Core I/O Cards
"Accessing a
153).
207