Peripherals; Ide Diskette Drive; Hard Drives; Dvd Drive - HP server rx4610 Service Manual

Chapter 1

Peripherals

IDE Diskette Drive

The server supports a slimline IDE diskette drive for 1.44 MB and 120 MB media. This half-inch slimline
peripheral mounts directly above the top-right power bay on the front of the chassis. The drive is mounted
on a removable tray that facilitates system assembly and service.

Hard Drives

The server supports up to two hot-swap drive carriers that support standard 1-inch high by 3.5-inch-wide
LVDS SCSI hard drives.
As part of the hot-swap implementation, drive carriers with integral heat sinks house the drives. Each drive
is mounted in a carrier with four fasteners and the carrier snaps into the hard drive bay. When a carrier is
seated properly in the bay, it snaps into place and leaves the locking handle exposed to the front of the
chassis. Drives can consume up to 24 watts of power and must be specified to run at a maximum ambient
temperature of 40 ° C (104 ° F).

DVD Drive

The server supports a slimline IDE DVD drive. This peripheral mounts directly above the top-left power bay
on the front of the chassis. The drive is mounted on a removable tray that facilitates system assembly and
service.

Power Supplies

The server is shipped with four power supplies. However, the server can operate with only three power
supplies. The third power supply provides redundancy. Each power supply has a dual rating of 800W
minimum over an input range of 180-264VAC and 700W minimum over an input range of 90-132VAC. Each
supply is designed to minimize EMI and RFI. Each power supply also has self-contained fans for cooling.
The DC output voltages of each power supply are:
• +48 V
•
+12 V standby
Each supply docks to a 28-pin connector on the front of the Power Distribution Board (T-Docking board).
General Information
5