Removing The Front Bezel; Replacing The Front Bezel; Front And Top Covers; Removing The Front Cover - HP rp4410 Service Manual

Removing the Front Bezel

Remove the front bezel by grasping the outer edges of the front bezel and pulling straight out.
Figure 6-3 Removing and Replacing the Front Bezel

Replacing the Front Bezel

Replace the front bezel by pushing the front bezel straight into the chassis until it snaps into
place.

Front and Top Covers

CAUTION:
the server without the front and top covers in place makes the server susceptible to electromagnetic
interference (EMI) and overheating problems that result in system failure.
Observe all electrostatic discharge (ESD) safety precautions before attempting this procedure.
Failure to follow ESD safety precautions can result in damage to the server.
NOTE:
When the front or top cover is removed, the chassis fan units increase to high speed to
assist cooling. When the top cover is replaced at the end of the operation, the chassis fans return
to normal speed.

Removing the Front Cover

CAUTION:
behind the front cover are cold-swappable and require power to be off.
To remove the front cover, follow these steps:
152 Removing and Replacing Components
Do not operate the server without the front and top covers in place. Operation of
Power the server off before removing the front cover. All components accessible