Olx Dividers; Removing An Olx Divider - HP rp4410 Service Manual

OLX Dividers

OLX dividers are located on the I/O baseboard assembly between the PCI cards. Six OLX dividers
provide short circuit protection to the hot-pluggable PCI accessory boards by preventing
inadvertent contact between boards during the replacement or addition of a board.
Additionally, each OLX divider has two light pipes that transfer illumination from one green
power LED and one amber attention LED mounted on the I/O baseboard, to the top of the divider.
The light pipes enables you to view the LED status when the top cover is removed.
WARNING!
from the server before removing or replacing a PCI card divider.
Voltages are present at various locations within the server whenever an ac power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server.

Removing an OLX Divider

NOTE: An alternative method of removing OLX dividers is to remove all OLX dividers at once
by removing the rack they are mounted in from the I/O baseboard assembly, then removing or
replacing the individual OLX divider, and then replacing the rack back on the I/O baseboard.
The OLX divider rack is attached to the I/O baseboard with four Torx T15 fasteners.
To remove an OLX divider, follow these steps:
1. If rack-mounted, slide the server out from the rack until it stops. See
Rack-Mounted Server" (page
2. Remove the top cover. See
3. To unlock the OLX divider from the chassis wall, pull up on the manual retention latch.
Ensure that the system is powered off and all power sources have been disconnected
Observe all ESD safety precautions before attempting this procedure. Failure to
"Removing the Top Cover" (page
149).
"Accessing a
153).
OLX Dividers 191