Bch Main Menu Commands And Submenus; Boot Command; Path Command; Boot Paths - HP rp4410 Service Manual

Table B-2 lists the boot paths.
Table B-2 Boot Paths
Boot Source
Bottom Disk – Slot 1 (SCSI ID = 0)
Top Disk – Slot 2 (SCSI ID = 1)
DVD

BCH Main Menu Commands and Submenus

The following sections provide information and examples of the submenus and commands in
the BCH firmware user interface.
The BCH Main Menu is the first menu displayed when you enter the firmware user interface.
The other menus available are listed in this menu. To view the commands available from this
menu, enter DI (display).
Access other menus by entering the name of the menu at the command prompt. From a given
menu, you can run a command from any other menu by entering the menu name that is associated
with the command, followed by the command. For example, to run the TI (time) command (in
the COnfiguration menu) from the Main Menu, enter co ti. To see all available commands
listed under their respective menus, enter HE (help) MA (main).
Example screen output of the BCH Main Menu:
---- Main Menu ---------------------------------------------------------------
Command
-------
BOot [PRI|ALT|<path>]
* PAth [PRI|ALT|CON|KEY] [<path>]
SEArch [DIsplay|IPL] [<path>]
COnfiguration menu
INformation menu
SERvice menu
DIsplay
HElp [<menu>|<command>]
RESET
----
Main Menu: Enter command or menu >
* You cannot modify the keyboard path.

Boot Command

To initiate the boot sequence from any menu in the interface, use the BO (boot) command. You
can enter either a default or specified path to the boot device. This path must be the definition
of a device, for example, FWSCSI.6.0 or PRI. The default is PRI.

Path Command

The PA (path) command displays or sets the current paths. Invoked with only one argument, PA
displays the current path of the entity passed as argument. For example, path alt displays the
current alternative boot path, and path pri fwscsi.6.0 sets up the primary boot path as
the device attached to SCSI controller with ID 6 and LUN 0. You can also set and display the
paths of console (graphics/serial) and keyboard. For example:
Main Menu: Enter command or menu > pa
Primary boot path:
236 Utilities
Boot Path
0/1/1/0.0.0 (Simplex Mode)
0/1/1/1.0.0 (Duplex Mode)
0/1/1/0.1.0 (Duplex Mode)
0/0/3/0.0
Description
-----------
Boot from specified path
Display or modify a path
Search for boot devices
Displays or sets boot values
Displays hardware information
Displays service commands
Redisplay the current menu
Display help for menu or command
Restart the system
intscsia.1
0/1/1/0.1
0/01/01/0.1 (hex)