Hot-Plug Procedures; Ola; Pci/Pci-X Card Slot Frequency And Bus Mode Compatibility For Shared Slots - HP rp4410 Service Manual

Table 3-1 1 PCI/PCI-X Card Slot Frequency and Bus Mode Compatibility for Shared Slots
Current PCI Bus Mode and
Frequency for the Current Card
in a Shared Slot
PCI 33 MHz
PCI 66 MHz
PCI-X 66 MHz
PCI-X 133 MHz
PCI-X 66 MHz)
1 The conditions described in this table apply only to shared slots (slots 3 and 4 on bus number 2, slots 5 and 6 on bus
number 3). Slots 7 and 8 are not shared slots.
2 Compatible: card is accepted and runs at the frequency shown.
3 Incompatible frequency: card does not work.
4 Incompatible bus: Card does not work. The new card does not initialize and powers off.
5 Maximum bus mode and frequency supported on shared slots is PCI-X 66 MHz.

Hot-Plug Procedures

The hot-plug procedures described in this section use the hardware interface only. Software
interface procedures are described in
IMPORTANT:
critical to the server operation. If you replace a card that is still operating and it is a critical
resource to the server, you can cause undesired system downtime.

OLA

Before installing a PCI/PCI-X card, ensure that the proper drivers for that PCI/PCI-X card are
installed.
NOTE:
If you are installing the Graphics Kit A6150B, use slots 3-8. However, DO NOT install
the included USB card. The server currently supports USB and the ports are already located on
the rear of the server.
If you are installing the RAID card A7143A, you must install it into slot 8. If you install this card
in any other slot, it interferes with the manual retention latch (MRL) on the OLX divider in the
next slot. Because of this interference, you can install only two RAID cards in the server in slot
1 and slot 8.
To add a PCI/PCI-X card into an empty slot, follow these steps:
1. If rack-mounted, slide the server out from the rack until it stops. See
from the Rack" (page
2. Remove the top cover from the chassis. (See
3. Choose an empty slot and pull up on the MRL located on the OLX divider approximately
75 degrees.
Cards to be installed
PCI 33 MHz
Compatible
Incompatible
3
frequency
Incompatible
3
frequency
5
Running at Incompatible
3
frequency
Before adding or replacing a PCI/PCI-X card, determine whether that card is
58).
(Figure 3-33)
PCI 66 MHz
2 2
Compatible
New card running at
33 MHz
2
Compatible
New card running at
66 MHz
4
Incompatible bus
Incompatible
3
frequency
Table 3-10 (page 89).
"Removing the Top Cover" (page
PCI-X 66 MHz PCI-X 133 MHz
2
Compatible Compatible
New card running at New card running at
33 MHz 33 MHz
2
Compatible Compatible
New card running at New card running at
66 MHz 66 MHz
2
Compatible Compatible
New card running at New card running at
66 MHz 66 MHz
2
Compatible Compatible
New card running at New card running at
66 MHz 66 MHz
"Extend the Server
Installing Additional Components
1
2
2
2
2
65).)
91