set port advertise
Parameters
port‐string
Defaults
If port‐string is not specified, advertisement for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display advertisement status for Gigabit ports 13 and 14:
D2(su)->show port advertise ge.1.13-14
ge.1.13
-------------------------------------------------
10BASE-T
10BASE-TFD
100BASE-TX
100BASE-TXFD
1000BASE-T
1000BASE-TFD
pause
ge.1.14
-------------------------------------------------
10BASE-T
10BASE-TFD
100BASE-TX
100BASE-TXFD
1000BASE-T
1000BASE-TFD
pause
set port advertise
Use this command to configure what a port will advertise for speed/duplex capabilities in auto‐
negotiation.
Syntax
set port advertise {port-string}{10t | 10tfd | 100tx | 100txfd | 1000t | 1000tfd
| pause}
Parameters
port‐string
10t
10tfd
100tx
4-16 Port Configuration
(Optional) Displays advertised ability for specific port(s). For a
detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐1.
capability
advertised
yes
yes
yes
yes
yes
yes
yes
yes
no
no
yes
yes
yes
yes
capability
advertised
yes
yes
yes
yes
yes
yes
yes
yes
no
no
yes
yes
yes
yes
Select the ports for which to configure advertisements. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
Advertise 10BASE‐T half duplex mode.
Advertise 10BASE‐T full duplex mode.
Advertise 100BASE‐TX half duplex mode.
remote
yes
yes
yes
yes
no
yes
no
remote
yes
yes
yes
yes
no
yes
no