Set Spantree Spanguardtrapenable; Clear Spantree Spanguardtrapenable - Enterasys D2 D2G124-12P Cli Reference Manual

Syntax
show spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the state of the SpanGuard trap function:
D2(ro)->show spantree spanguardtrapenable
Spanguard SNMP traps are enabled

set spantree spanguardtrapenable

Use this command to enable or disable the sending of an SNMP trap message when SpanGuard
has locked a port.
Syntax
set spantree spanguardtrapenable {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable the SpanGuard trap function:
D2(su)->set spantree spanguardtrapenable disable

clear spantree spanguardtrapenable

Use this command to reset the Spanning Tree SpanGuard trap function back to the default state of
enabled.
Syntax
clear spantree spanguardtrapenable
Disables or enables sending SpanGuard traps. By default, sending traps
is enabled.
set spantree spanguardtrapenable
D-Series CLI Reference 6-29