Set Dhcp Pool Netbios-Node-Type; Clear Dhcp Pool Netbios-Node-Type - Enterasys D2 D2G124-12P Cli Reference Manual

set dhcp pool netbios-node-type

set dhcp pool netbios-node-type
Use this command to specify a NetBIOS node (server) type for the DHCP clients served by the
address pool being configured.
Syntax
set dhcp pool poolname netbios-node-type {b-node | h-node | p-node | m-node}
Parameters
poolname
b‐node
h‐node
p‐node
m‐node
Defaults
None.
Mode
Switch command, read‐write.
Example
This example specifies hybrid as the NetBIOS node type for the address pool "auto1."
D2(rw)->set dhcp pool auto1 netbios-node-type h-node

clear dhcp pool netbios-node-type

Use this command to remove the NetBIOS node type from the address pool being configured.
Syntax
clear dhcp pool poolname netbios-node-type
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
14-26 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the NetBIOs node type to be broadcast (no WINS).
Specifies the NetBIOs node type to be hybrid (WINS, then broadcast).
Specifies the NetBIOs node type to be peer (WINS only).
Specifies the NetBIOs node type to be mixed (broadcast, then WINS).
Specifies the name of the address pool. Pool names may be up to 31
characters in length.