Clear Policy All-Rules - Enterasys D2 D2G124-12P Cli Reference Manual

profile‐index
all‐pid‐entries
ether
icmptype
ipproto
ipdestsocket
ipsourcesocket
iptos
macdest
macsource
tcpdestport
tcpsourceport
udpdestport
udpsourceport
Defaults
When applicable, data and mask must be specified for individual rules to be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to delete Ethernet II Type 1526 classification rule entries associated with
policy profile 1 from all ports
D2(su)->clear policy rule 1 ether 1526
This example shows how to remove a rule from policy profile 5 that will forward UDP frames
from source port 45:
D2(su)->clear policy rule 5 udpportsource 45 forward

clear policy all-rules

Use this command to remove all policy classification rules.
Syntax
clear policy all-rules
Parameters
None.
Defaults
None.
Specifies a policy profile for which to delete classification rules. Valid
profile‐index values are 1 ‐ 255.
Deletes all entries associated with the specified policy profile.
Deletes associated Ethernet II classification rule.
Deletes associated ICMP classification rule.
Deletes associated IP protocol classification rule.
Deletes associated IP destination classification rule.
Deletes associated IP source classification rule.
Deletes associated IP Type of Service classification rule.
Deletes associated MAC destination address classification rule.
Deletes associated MAC source address classification rule.
Deletes associated TCP destination port classification rule.
Deletes associated TCP source port classification rule.
Deletes associated UDP destination port classification rule.
Deletes associated UDP source port classification rule.
clear policy all-rules
D-Series CLI Reference 9-13