Enterasys D2 D2G124-12P Cli Reference Manual page 378

set rmon history
Parameters
port‐string
Defaults
If port‐string is not specified, information about all RMON history entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON history entries for Gigabit Ethernet port 1 in switch 1.
A control entry displays first, followed by actual entries corresponding to the control entry. In this
case, the default settings for entry owner, sampling interval, and maximum number of entries.
(buckets) have not been changed from their default values. For a description of the types of
statistics shown, refer to Table
D2(su)->show rmon history ge.1.1
:
Port: ge.1.1
-------------------------------------
Index 1
Owner
Status
Data Source
Interval
Buckets Requested = 50
Buckets Granted
Sample
Drop Events
Octets
Packets
Broadcast Pkts
Multicast Pkts
CRC Align Errors
set rmon history
Use this command to configure an RMON history entry.
Syntax
set rmon history index [port-string] [buckets buckets] [interval interval] [owner
owner]
Parameters
index‐list
port‐string
buckets buckets
interval interval
owner owner
13-6 RMON Configuration
(Optional) Displays RMON history entries for specific port(s).
13‐44.
= monitor
= valid
= ifIndex.1
= 30
= 10
2779 Interval Start: 1 days 0 hours 2 minutes 22 seconds
= 0
= 0
= 0
= 0
= 0
= 0
Specifies an index number for this entry.
(Optional) Assigns this entry to a specific port.
(Optional) Specifies the maximum number of entries to maintain.
(Optional) Specifies the sampling interval in seconds.
(Optional) Specifies an owner for this entry.
Undersize Pkts = 0
Oversize Pkts = 0
Fragments = 0
Jabbers = 0
Collisions = 0
Utilization(%) = 0