Set Lacp; Set Lacp Asyspri - Enterasys D2 D2G124-12P Cli Reference Manual

set lacp

Table 4-16 show lacp Output Details (Continued)
Output Field
Admin Key
Oper Key
Attached Ports
set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device.
Syntax
set lacp {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable LACP:
D2(su)->set lacp disable

set lacp asyspri

Use this command to set the LACP system priority.
Syntax
set lacp asyspri value
Parameters
asyspri
value
Defaults
None.
4-38 Port Configuration
What It Displays...
Port's assigned key. D-Series devices provide a default admin key value of 32768 for
all LAG ports (lag.0.1 though lag.0.6).
Port's operational key, derived from the admin key. Only underlying physical ports
with oper keys matching the aggregator's will be allowed to aggregate.
Underlying physical ports associated with this aggregator.
Disables or enables LACP.
Sets the system priority to be used in creating a LAG (Link Aggregation
Group) ID. Valid values are 0 to 65535.
Specifies a system priority value. Valid values are 0 to 65535, with
precedence given to lower values.