Show Spantree Legacypathcost; Set Spantree Legacypathcost - Enterasys D2 D2G124-12P Cli Reference Manual

show spantree legacypathcost

Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the SpanGuard trap function to enabled:
D2(rw)->clear spantree spanguardtrapenable
show spantree legacypathcost
Use this command to display the default Spanning Tree path cost setting.
Syntax
show spantree legacypathcost
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the default Spanning Tree path cost setting.
D2(su)->show spantree legacypathcost
Legacy Path Cost is disabled.

set spantree legacypathcost

Use this command to enable or disable legacy (802.1D) path cost values.
Syntax
set spantree legacypathcost {disable | enable}
Parameters
disable
enable
6-30 Spanning Tree Configuration
Use 802.1t2001 values to calculate path cost.
Use 802.1d1998 values to calculate path cost.