Clear Config; Using And Configuring Webview; Purpose - Enterasys D2 D2G124-12P Cli Reference Manual

Examples
This example shows how to reset the system:
D2(su)->reset
This command will reset all modules and may disconnect your telnet session.
Do you want to continue (y/n) [n]?

clear config

Use this command to clear the user‐defined configuration parameters.
Syntax
clear config
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Usage
Executing this command will clear the configuration in both NVRAM and on the memory card, if
one is installed on the switch.
This command will not clear the IP address of the switch. Use the clear ip address command to
clear the IP address.
Example
This example shows how to clear configuration parameters:
D2(su)->clear config

Using and Configuring WebView

Purpose

By default, WebView (The Enterasys Networks embedded web server for switch configuration
and management tasks) is enabled on TCP port number 80 on the D‐Series switch. You can verify
WebView status, and enable or disable WebView using the commands described in this section.
WebView can also be securely used over SSL port 443, if SSL is enabled on the switch. By default,
SSL is disabled.
To use WebView, type the IP address of the switch in your browser. To use WebView over SSL,
type in https:// then the IP address of the switch. For example, https://172.16.2.10.
clear config
D-Series CLI Reference 2-51