Disconnect - Enterasys D2 D2G124-12P Cli Reference Manual

disconnect

Mode
Switch command, read‐only.
Example
This example shows how to use the show users command. In this output, there are two Telnet
users logged in with Read‐Write access privileges from IP addresses 134.141.192.119 and
134.141.192.18:
D2(su)->show users
Session
-------- ----- --------------------------
* telnet
telnet
disconnect
Use this command to close an active console port or Telnet session from the switch CLI.
Syntax
disconnect {ip-addr | console}
Parameters
ip‐addr
console
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to close a Telnet session to host 134.141.192.119:
D2(su)->disconnect 134.141.192.119
This example shows how to close the current console session:
D2(su)->disconnect console
12-14 Logging and Network Management
User Location
rw 134.141.192.119
rw 134.141.192.18
Specifies the IP address of the Telnet session to be disconnected. This
address is displayed in the output shown in "show users" on page 12‐15.
Closes an active console port.