Set Rmon Event Status; Clear Rmon Event - Enterasys D2 D2G124-12P Cli Reference Manual

D-series ethernet switches
Table of Contents

Advertisement

set rmon event status

Example
This example shows how to create and enable an RMON event entry called "STP topology 
change" that will send both a log entry and an SNMP trap message to the "public" community:
D2(rw)->set rmon event properties 2 description "STP topology change" type both
community public owner Manager
set rmon event status
Use this command to enable an RMON event entry. An event entry describes the parameters of an 
RMON event that can be triggered. Events can be fired by RMON alarms and can be configured to 
create a log entry, generate a trap, or both. 
Syntax
set rmon event status index enable
Parameters
index
enable
Defaults
None.
Mode
Switch command, read‐write.
Usage
An RMON event entry can be created using this command, configured using the set rmon event 
properties command ("set rmon event properties" on page 13‐13), then enabled using this 
command. An RMON event entry can be created and configured at the same time by specifying an 
unused index with the set rmon event properties command.
Example
This example shows how to enable RMON event entry 1:
D2(rw)->set rmon event status 1 enable

clear rmon event

Use this command to delete an RMON event entry and any associated log entries.
Syntax
clear rmon event index
Parameters
index
13-14 RMON Configuration
Specifies an index number for this entry. Maximum number of entries is 
100. Maximum value is 65535.
Enables this event entry.
Specifies the index number of the entry to be cleared.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Enterasys d2 d2g124-12D2g124-12D2g124-12p

Table of Contents