Show Pwa Session - Enterasys D2 D2G124-12P Cli Reference Manual

port‐string
Defaults
If port‐string is not specified, PWA will enabled on all ports.
Mode
Switch command, read‐write.
Example
This example shows how to enable PWA on ports 1‐22:
D2(su)->set pwa portcontrol enable ge.1.1-22

show pwa session

Use this command to display information about current PWA sessions.
Syntax
show pwa session [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, session information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display PWA session information:
D2(su)->show pwa session
Port
-------- ----------------- --------------- ------------- ------------ ---------
ge.2.19
ge.2.19
ge.2.19
(Optional) Sets the control mode on specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 4‐1.
(Optional) Displays PWA session information for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐1.
MAC IP
00-c0-4f-20-05-4b 172.50.15.121
00-c0-4f-24-51-70 172.50.15.120
00-00-f8-78-9c-a7 172.50.15.61
User Duration
pwachap10 0,14:46:55
pwachap1 0,15:43:30
pwachap11 0,14:47:58
D-Series CLI Reference 15-67
show pwa session
Status
active
active
active