Installation Procedures; Installing The Control Unit And Modules - Lucent Technologies PARTNER II Release 4.1 Installation Manual

Installation Procedures

Before installing the system, be sure you read the safety
instructions on page ii.
WARNING:
There are no customer-serviceable components
inside the system modules or backplane. There are
hazardous voltages within that can cause severe or
fatal personal injury. DO NOT OPEN THE MODULES.

Installing the Control Unit and Modules

Install the control unit's backplane within five feet (1.5
meters) of a properly grounded electrical outlet (not
controlled by a switch) and the network interface jacks.
In addition, when you mount the backplane on the wall,
leave at least six inches (15.2 cm) of clearance at the top
and sides, and two feet (0.6 meters) at the front and
bottom to ensure proper ventilation.
1
A) Hold the backplane against the wall. (If you
are also installing the expansion carrier, plan
to install it to the right of the primary carrier,
leaving 6" to 24" (15.2 to 61 cm) between the
carriers.)
B) Using the four screw keyholes in the backplane
as a template, mark screw locations on the
wall.
C) Start four #12 screws, leaving the screw heads
approximately 1/4" (.64 cm) away from the
wall.
D) Slip the backplane onto the screws, then
tighten them.
If you are mounting the expansion carrier,
E)
repeat this step.
2
A) Slide the primary processor module into the
center slot of the primary carrier. Push slowly
but firmly in the center of the module until the
module locks into place, and is attached to
the rear of the backplane. Do not force the
module. If it does not insert easily, remove
the module, clear any obstruction, and
reinsert it.
If you have an expansion carrier, slide the
B)
expansion processor module into its center
slot until the module locks into place.
8
Installation Procedures
Backplane