Assigning CoS Interfaces Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the
Interface Cos/QoS Settings page.
Table 9-95. CoS Interface CLI Commands
CLI Command
qos trust
qos cos default-cos
no qos trust
The following is an example of the CLI commands:
Console (config)# interface ethernet g5
Console (config-if)# qos trust
Console (config-if)# qos cos 3
Description
Enables trust state for each.
Configures the default port CoS value.
Disables Trust state on each port.
Configuring Quality of Service
343