Cos Interface Configuration Commands; Interface Queue Configuration - Dell PowerConnect 7048P Manual

CoS Interface Configuration Commands

Beginning in Privileged Exec mode, use the following commands in to
configure the traffic shaping and WRED exponent values for an interface.
CLI Command
configure
interface
interface
bw
traffic-shape
random-detect exponential-
weighting-constant

Interface Queue Configuration

Beginning in Privileged Exec mode, use the following commands in to
configure and view CoS interface queue settings.
CLI Command
configure
interface
interface
cos-queue min-bandwidth
bw
cos-queue strict
cos-queue random-detect
queue-id
exit
1126
Configuring Class-of-Service
Description
Enter Global Configuration mode.
Enter Interface Configuration mode, where
is replaced by gigabitethernet
tengigabitethernet
port-channel number
kbps Sets the upper limit on how much traffic can leave a
port. The
bandwidth value from 64 to 4294967295 kbps.
Configure the WRED decay exponent (range: 0–15)
exponent
for the interface.
Description
Enter Global Configuration mode.
Enter Interface Configuration mode, where
replaced by gigabitethernet
tengigabitethernet
channel number
Specify the minimum transmission bandwidth (range:
0-100% in 1% increments) for each interface queue.
queue-id
Activate the strict priority scheduler mode for each
specified queue. The
Set the queue management type for the specified
queue to WRED. The no version of this command
resets the value to taildrop.
Exit to Global Config mode.
unit/slot/port
.
bw
variable represents the shaping
unit/slot/port
unit/slot/port
.
queue-id
interface
unit/slot/port
,
, or port-channel
interface
,
., or port-channel
value ranges from 0 to 6.
is
port-