Snmp Community Cli Commands - Dell PowerConnect 5324 User Manual

Configuring Communities Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNMP Community page.
Table 6-43. SNMP Community CLI Commands
CLI Command
snmp-server community
string [ro | rw | su] [ip-
address]
snmp-server host {ip-address
| hostname} community-
string [1 | 2]
show snmp
The following is an example of the CLI commands:
console(config)# snmp-server community public_1 su 1.1.1.1
console(config)# snmp-server community public_2 rw 2.2.2.2
console(config)# snmp-server community public_3 ro 3.3.3.3
console(config)# snmp-server host 1.1.1.1 public_1 1
console(config)# snmp-server host 2.2.2.2 public_2 2
console(config)#
console# show snmp
Community-String
-------------------------------------
public_1
public_2
public_3
Traps are enabled.
Authentication-failure trap is enabled.
Trap-Rec-Address
180
Configuring System Information
Description
Sets up the community access string to permit
access to SNMP protocol.
Determines the trap type sent to the selected
recipient.
Checks the SNMP communications status.
Community-Access
super
readwrite
readonly
Trap-Rec-Community
IP address
1.1.1.1
2.2.2.2
3.3.3.3
Version