Add A Static Interface - Dell PowerConnect 5324 User Manual

Remove — When selected, removes the interface from the IP Address drop-down menu.
Adding an IP Interface
1
Open the IP Interface Parameters page.
2
Click Add.
The Add a Static Interface page opens:
Figure 6-36. Add a Static Interface
3
Complete the fields on the page.
Network Mask specifies the subnetwork mask of the source IP address.
4
Click Apply Changes.
The new interface is added, and the device is updated.
Modifying IP Address Parameters
1
Open the IP Interface Parameters page.
2
Select an IP address in the IP Address drop-down menu.
3
Modify the required fields.
4
Click Apply Changes.
The parameters are modified, and the device is updated.
Deleting IP Addresses
1
Open the IP Interface Parameters page.
2
Click Show All.
The Interface Parameters Table opens:
Configuring System Information
121