Defining Traps; Snmp Trap Settings - Dell PowerConnect 5324 User Manual

Defining Traps

From the SNMP Trap Settings page, the user can enable or disable the device to send SNMP traps
or notifications. To open the SNMP Trap Settings page, click System
view.
Figure 6-73. SNMP Trap Settings
SNMP Trap — Enables sending SNMP traps or SNMP notifications from the device to defined
trap recipients.
Authentication Trap — Enables sending SNMP traps when authentication failed to define
recipients.
Select Recipient IP — Specifies the IP address to whom the traps are sent.
Community String — Identifies the community string of the trap manager.
Traps — Determines the trap type sent to the selected recipient. The possible field values are:
SNMP V1 — SNMP Version 1 traps are sent
SNMP V2c — SNMP Version 2 traps are sent
Remove — Removes Trap Manager Table entries, when selected.
Enabling SNMP traps on the Device
1
Open SNMP Trap Settings page.
2
Select Enable in the SNMP Trap drop-down list.
3
Define the fields.
4
Click Apply Changes.
182
Configuring System Information
SNMP Traps in the tree