Configuring Static Address Parameters Using CLI Commands
The following table summarizes the equivalent CLI commands for configuring static address
parameters as displayed in the Static MAC Address page.
Table 7-57. Static Address CLI Commands
CLI Command
bridge address mac-address {ethernet
interface | port-channel port-channel-
number} [permanent | delete-on-reset |
delete-on-timeout | secure]]
show bridge address-table [vlan vlan]
[ethernet interface | port-channel port-
channel-number]
The following is an example of the CLI commands:.
Console# show bridge address-table
Aging time is 300 sec
vlan
mac address
----
------------
1
00:60:70:4C:73:FF
1
00:60:70:8C:73:FF
200
00:10:0D:48:37:FF
g8
00:10:0D:98:37:88
Description
Adds a static MAC-layer station source
address to the bridge table.
Displays entries in the bridge-forwarding
database.
port
----
g8
g8
g9
g8
type
--------
dynamic
dynamic
static
dynamic
Configuring Device Information
233