Dell 5310n - Workgroup Laser Printer B/W Service Manual page 80

Service manual
Table of Contents

Advertisement

User attendance messages (continued)
Error
Sub
Primary message
code
code
31
.xx
Defective Print Cartridge
32
.xx
Unsupported Print
Cartridge
34
.xx
Short Paper
36
.xx
Resolution Reduced
37
.xx
Insufficient Collation
Area
Service Manual
2-38
Description/action
Error code 31 displays when the top front cover is closed and a defective
print cartridge is detected. It may take the printer 10-20 seconds to
determine if the print cartridge is defective. Depending on the setting of the
Machine Class ID the printer may be allowed to print pages during this 10-20
second interval. If pages are allowed to print, they are not reprinted once a
good print cartridge is inserted.
Note: This error indicates the printer was able to read the cartridge ID, but
the ID did not pass the verification test. To pass the verification test, the ID
read from the print cartridge must match the ID from the last "good" print
cartridge or the same ID must be read from the print cartridge twice. The last
"good" print cartridge ID is stored in NVRAM.
Error 32 displays when the top cover is closed and an unsupported print
cartridge is detected. It may take the printer 10-20 seconds to determine if
the print cartridge is supported. Depending on the setting of the Machine
Class ID the printer may be allowed to print pages during this 10-20 second
interval. If pages are allowed to print, then they are not reprinted once a
good print cartridge is inserted. If this does not fix the problem, go to
"Signature button assembly service check" on page
The printer determines the paper length is too short to print the formatted
data. This occurs when the printer does not know the actual paper size
loaded in the tray. For auto-size sensing trays, this error occurs if the paper
stop is in the incorrect position. Make sure the Paper Size setting is correct
for the size paper that is being used.
The resolution of the page has been reduced from 600 dpi to 300 dpi to
prevent a Memory Full error. This message can only occur if the Resolution
Reduction setting is turned on.
Note: 1200 dpi pages are not resolution reduced. If a 1200 dpi job runs out
of memory, a Memory Full error displays.
This message displays when the printer memory is insufficient to perform the
Flash Memory Defragment operation.
Note: This message is posted prior to the actual start of the defragment
operation. The printer code determines if enough printer memory is available
to complete the defragment operation. The user should not be concerned
with losing resources stored in the flash option.
The following actions may be taken:
• Press
to clear the message. To perform the defragment operation:
- Delete fonts, macros, and other data in RAM.
- Install additional printer memory.
• Press
until Busy/Waiting appears. The following actions are
available:
- Cancel Job
- Reset Printer
- Reset Active Bin
2-123.

Advertisement

Table of Contents
loading

This manual is also suitable for:

5210n5310n

Table of Contents