Upper paper deflector assembly removal
Either lift the ESD cover out of the way or remove it. See
1.
Note: The tabs holding the ESD cover are easily stressed or broken.
Lift the left side to release the small tab (A) on the left and the MPF flag (B) and slide the upper paper
2.
deflector assembly to the right to unlatch the hooks (C) on the right.
Note: Be careful not to put too much stress on the small tab (A) on the right.
A
Lift to remove the upper paper deflector assembly.
3.
Installation note: Make sure the MPF flag (B) is in place.
USB board assembly removal
Remove the upper front cover.
1.
Disconnect the USB cable from the USB board assembly.
2.
Remove the screw (A) securing the USB board assembly.
3.
Service Manual
4-80
"ESD cover removal" on page
B
C
4-26.