Dell 5310n - Workgroup Laser Printer B/W Service Manual page 102

Service manual
Table of Contents

Advertisement

User attendance messages—paper jams and paper handling errors (2xx.xx)
Error
Sub
Description
code
codes
202
.32
Exit sensor covered too
long. Fuser page count
between 300,000 and
399,999.
202
.33
Page is covering the
narrow media sensor
during warm up. Fuser
page count between
300,000 and 399,999.
202
.34
Exit sensor may have
bounced. Fuser page
count between 300,000
and 399,999.
202
.36
Page is covering the exit
sensor during warm up.
Fuser page count
between 300,000 and
399,999.
Service Manual
2-60
Possible causes
Page may be jammed in fuser exit or
redrive area.
• If page is not visible from front or rear
of the printer, a partial piece of a
page may be torn off in the fuser
covering the narrow media sensor.
• The narrow media sensor or fl a g may
be dislodged or damaged.
Exit sensor assembly.
Something is keeping the exit sensor
covered. A page may not have been
cleared from a prior jam.
Action
• Make sure the redrive door
is complete closed.
• Check the fuser for any
signs of wear or
contamination. If any are
found, replace the fuser
assembly. See
"Fuser
assembly removal" on
page
4-27.
• Turn media over to reduce
+W curl.
• Check upper redrive
diverter and diverter spring
for any signs of damage, a
loose spring, or binding
parts. Repair the redrive as
necessary.
• Check any installed output
options(s) that may be
installed for correct
installation and alignment.
• The fuser exit sensor may
not be functioning properly.
Go to
"Fuser exit sensor
service check" on
page
2-92.
Check the fuser and area
around the fuser assembly for
any signs of debris or pieces of
paper or media.
Go to
"Fuser exit sensor
service check" on page
2-92.
Check the fuser and area
around the fuser assembly for
any signs of debris or pieces of
paper or media.

Advertisement

Table of Contents
loading

This manual is also suitable for:

5210n5310n

Table of Contents