Installation; Removing Or Installing A Flash Memory Or Firmware Card; Removal - Dell 5310n - Workgroup Laser Printer B/W Service Manual

Service manual
Table of Contents

Advertisement

Installation

Note: Printer memory cards designed for other printers may not work with the printer.
Remove the system board access cover. (See
1.
Warning: Printer memory cards are easily damaged by static electricity. Touch something metal such as
the printer frame before you touch a memory card.
Push open the latches (A) on both ends of the memory card connector.
2.
Unpack the memory card.
3.
Avoid touching the connection points along the edge of the card. Save the packaging.
Align the notches on the bottom of the card (B) with the notches on the connector (C).
4.
Push the memory card firmly into the connector until the latches on either end of the connector snap into
5.
place.
It may require some force to fully seat the card.
Make sure each latch fits over the notch on the end of the card.
6.

Removing or installing a flash memory or firmware card

Removal

Remove the system board access cover. (See
1.
Note: If an option card has been installed, you may need to remove the option card before removing the
flash memory or firmware card.
Squeeze the flash memory or firmware card locking clips.
2.
Pull the card out.
3.
Avoid touching the metal pins on the bottom of the card.
Place the flash memory or firmware card in its original packaging.
4.
If you do not have the original packaging, wrap the flash memory or firmware card in paper, and store it in
a box.
If you removed an option card to access the flash memory or firmware card, reinstall the option card. (See
5.
"Installing an option card" on page
Service Manual
A-8
C
A
B
A-10.)
"Accessing the printer system board" on page
A
"Accessing the printer system board" on page
A-5.)
A-5.)

Advertisement

Table of Contents
loading

This manual is also suitable for:

5210n5310n

Table of Contents